Appendix 4: Event Log Messages - Reach PP5099 Manual

Appendix 4: Event Log Messages

LOG Event Value Description
Substitution attempt detected: a device communicates with the HUB
Sub. Attempt ON
using the same RF address of another device correctly paired.
Field Ch A Jam ON
Noise detected on RF Ch A.
Field Ch A
Back to normal condition.
Jam. OFF
Field Ch B
ON Noise detected on RF Ch B.
Jam.
Field Ch B
OFF Back to normal condition.
Jam.
Link Fault ON Device is not communicating with the HUB
Link Fault OFF Back to normal condition
Tamper ON Device is not communicating with the HUB
Tamper OFF Back to normal condition
Interface flt ON Isolators active
Interface flt OFF Back to normal condition
Date time
ON Date or time modified
edit
Batter A Low ON Battery A missing or low charge
Batter A Low OFF Back to normal condition
Batter B Low ON Battery B missing or low charge
Batter B Low OFF Back to normal condition
Alarm ON Device alarm
Alarm OFF Back to normal condition
Fault ON The fault is detailed with other log events
Fault OFF Back to normal condition
General Fault ON General device fault
General Fault OFF Back to normal conditions
Contamination ON Photo chamber contaminated
Contamination OFF Back to normal condition
In. Open ON Supervised module input open: EOL not found
In. Open OFF Back to normal condition
In. Short ON Supervised module input short: wiring short
In. Short OFF Back to normal condition
Out.Open ON Supervised module output channel open: EOL not found
Out.Open OFF Back to normal condition
Out. Short ON Supervised module output channel short: wiring short
Out. Short OFF Back to normal condition
Rel. Short ON Output activated
Rel. Short OFF Back to normal condition
Event Log
ON Event log cleared
Cleared
PP5099/2023/Issue 1
Action
Look for the device/devices that caused the
substitution attempt: LEDs blink amber two
times and repeat the blinking periodically.
Remove batteries.
Power cycle the Loop Interface.
Optional: Re-pair device.
Check for external RF interference.
Check for external RF interference.
Check for the device condition and position
Check for the device condition and position
Loop connection lost/down
Loop connection restored
-
Change both device batteries
Change both device batteries
-
-
Check the device condition
Check Optical Detector device photo chamber
Check for device wiring and EOL
Check for device wiring and EOL
Check for device wiring and EOL
Check for device wiring and EOL
-
-
Page 27 of 27