Table of Contents
Advertisement
Appendix 1: REACH / XPander RF Channel Map
When installing a REACH Wireless system within the wireless vicinity of each other, it is important to ensure that
both systems are:
1. Operating on different RF Frequencies
2. Maintaining a 0.05Mhz gap between each other
(1) should be the case for any RF wireless system install, including REACH-only or XPander-only systems. (2) is required
to prevent communication issues with XPander systems and is required for XPander-only or XPander/REACH mix
systems. REACH-only installations only need to be set to different channel pairs.
The REACH/XPander RF Map document will aid in the frequency/channel selection process if a REACH or XPander
wireless system is already installed in-range. To access the channel map, visit apollo-fire.co.uk/training-support/
rf-channel-map or scan this QR code:
Appendix 2: Device XP95 Device Codes
REACH Loop Interface Module
REACH Optical Smoke Detector
REACH Multisensor Smoke Detector
REACH Heat Detector
REACH Manual Call Point
REACH AV Devices
REACH Input Module
REACH Output Module
REACH Remote Indicator Module
Device
Type Code
S90
XP
4
16
5
20
5
23
6
24
7
31
1
4
4
17
2
8
2
8
PP5099/2023/Issue 1
Page 25 of 27
Advertisement
Table of Contents
