Installing The Ethernet Cable - Patton SmartNode 4110 Series User Manual
Voip gateway router
Hide thumbs
Also See for SmartNode 4110 Series:
- Quick start manual (13 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
SmartNode 4520 & 4110 Series User Manual
Note
Unit must not connect directly to telecom network voltage (TNV).
Installing the Ethernet cable
The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
figure 20
on page 34). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode's Ether-
net ports (see
table 7
for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the SmartNode
4110 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 4110
Series devices to a host (see
Table 7. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 4110 Series)
Note
Pins not listed are not used.
Figure 20. Connecting a SmartNode 4110 Series device to a hub
Installing the gateway router
figure 21
on page 35).
Pin
1
2
3
6
Signal
TX+
TX-
RX+
RX-
3 • Hardware installation
34
Advertisement
Table of Contents
