Table of Contents
Advertisement
Specifications
• Supports one single receiver
• Depending on receiver type and
location, can access the following
satellites:
DISH
®
Western Arc: 110°, 119°, 129°
DIRECTV
:119° or 101° (will not receive
®
HD on 110° or any KA-band HD on 99° and 103°)
Bell TV ™ : 91° or 82°
Safety Recommendations
Do not attempt to install this system in the rain
or under any wet conditions. Moisture may affect
electronics and void your warranty.
Do not paint this antenna. Painting the DuraSAT
antenna will void your warranty.
For best performance and to reduce signal acquisition time,
make sure the vehicle is on a level surface that is free of
obstructions such as trees or large buildings. Make sure you
have a clear view of the southern sky.
Unpacking the Unit
If using a knife to open carton, be careful. Do not cut
the dome on the unit.
Use two people when removing the unit from
the carton.
Open box, and remove packing material. Lift the unit out of
the box vertically. Do not turn box and "roll" out the unit. Do
not turn box upside-down to remove.
Overall Installation
TRUCK
1
• Elevation range: 18–65°
• Azimuth: 0–416°
• Max amperage: 2.0 A
• Unit operating voltage: 9 –16 V
• Supply voltage: 12–13.8 V
• UV-protected plastic dome
D4
®
DuraSAT D4
TV
Receiver
Coax Cable
12V plug or
Wall plate
Disclaimer
Although every effort has been made to ensure that the
information in this manual is correct and complete, no
company shall be held liable for any errors or omissions
in this manual. Changes and technological advances are
continuously being made in the satellite market. Information
provided in this manual was accurate at time of printing.
If the DuraSAT
antenna does not function as expected,
D4
®
please contact Winegard Company at 1-800-788-4417, or
visit our website at www.winegard.com/mobile.
Trademarks
Winegard is registered trademarks of Winegard Company.
DISH
is a registered trademark of DISH Network L.L.C.
®
DIRECTV
is a registered trademark of DIRECTV, Inc., a unit
®
of Hughes Electronics Corp. Bell TV
Canada, Inc.
Reference made to products or services provided by companies,
other than Winegard Company, does not represent any
endorsement of those products or services.
Installing the Cables
1)
Connect the quick disconnect power cable to the quick
disconnect power socket on the back of the
Quick disconnect power socket
MAIN port
2)
Decide the best location for the power and coax cables
to enter the vehicle. Decide the location of the power
switch and receiver. Drill a ¾" hole in the roof, and push
the wires inside, making sure the cables are accessible
from the area where the power switch and receiver will
be located.
3)
Connect a coax cable from the "Satellite in" port of
the primary receiver to the main port on the back of the
D4 unit.
Nicks or cuts in wiring jacket may cause water
to leak into vehicle.
™
is a trademark of Bell
DuraSAT
D4
®
Collar
DuraSAT
D4 In-Motion Antenna
®
unit.
Advertisement
Table of Contents
