Table of Contents
Advertisement
Quick Reference Guide
The DuraSAT
antenna switch settings are preset for
D4
®
DIRECTV. If you have a DISH or Bell TV receiver, you must
change the numbered switches found on the electronics box
under the dome.
(Factory preset
for DIRECTV)
DIRECTV
1
2
3
4
5
6
7
8
1
DIRECTV
Receiver Setup
®
Connect the receiver to a power source, and
complete receiver setup. Receiver setup for
the primary receiver follows; if your receiver
differs from the options shown, you may need
to consult your receiver manual.
Receiver setup instructions are accurate at time of printing
and may change without notice. Call Winegard tech line for
assistance: 1-800-788-4417.
Check out online receiver setup guides for your
antenna at www.winegard.com/support. For
more information on receiver compatibility and
programming, visit www.winegard.com/receivers.
DuraSAT D4 is not compatible with SWM-only
receivers.
1)
Press
Menu
on your remote, and then select
Parental, Fav's &
Setup.
2)
Select
System
Setup.
DuraSAT
D4 In-Motion Antenna
®
Key
0 =
1
=
DISH
Bell TV
2
3
4
5
6
7
8
1
2
3
4
DIRECTV
3)
In your receiver menu, you will need to identify
the Satellite Menu. Once there, find the option for
Satellite
Up
Down
5
6
7
8
4)
You may be required to press the
proceeding (underneath #7 on the remote).
5)
Select
3-LNB (18"x 20")
If given the option of SWM or Multi-switch, select
Multi
switch.
Power on the antenna, and allow the antenna a few
minutes to acquire signal. Once the antenna has
finished acquiring signal, the antenna will be silent.
6)
After the antenna has acquired signal, press
The receiver will automatically verify the setup.
7)
Errors may be displayed on the screen. It is normal
to see one or two boxes with an X instead of a
Select Continue.
8)
Select
Continue
The program guide will download.
Receiver Setup
®
Setup.
DASH (-)
or
3 Satellites
again.
(cont.)
before
Continue
.
2
Advertisement
Table of Contents
