Parts Included • Tools Needed • How to Unpack The Winegard RoadTrip is designed specifically for use with motorized recreational vehicles. Winegard recommends using a qualified installer familiar with RV structure and wiring to ensure proper installation and to prevent damage to RV or dish.
Control Unit ELEVATION MOTOR CONTROL UNIT MUST BE PARALLEL TO THE CENTER CENTER LINE OF THE LINE OF THE VEHICLE AND FACE VEHICLE FRONT OR REAR OF VEHICLE. Installation Diagram LNBF GPS ANTENNA (RoadTrip SDi ONLY) GPS CABLE (RoadTrip SDi ONLY)
After mounting the RoadTrip System to your rooftop, you must set the RoadTrip’s switch settings for the mountoing options chosen and satellite Television Service Provider. The chart below lists switch settings for both the RoadTrip SD and RoadTrip SDi. See page 3. of Operation Manual for detailed instructions.
Installing unit on roof of vehicle — Install in DRY conditions only! IMPORTANT! Do not install this system in the rain, or under any wet conditions. Mois- ture may affect electronics and void your warranty! 1. For best performance and to reduce signal ac- quisition time, park vehicle on a level surface;...
Installation GPS installation — (RoadTrip SDi only) 10. The GPS antenna is pre-wired and has a 1 meter cable running through one of the connectors. Determine location for GPS antenna. It is recom- mended you place the GPS antenna 3 feet from dome and away from any other obstruction.
Page 7
Connecting the receiver — Connecting one receiver 1. Connect the coax cable from the gray coax cable of the RoadTrip™ to the “SATELLITE IN” on the receiver. 2. See page 5 of Operations Manual for receiver set-up. Connecting two receivers 1.