Winegard DuraSAT D4 CM2000T Quick Start Manual page 5

DISH Receiver Setup
®
5) Select Check Switch.
6) Select Test.
It will go through a number of steps, then return to the
screen shown here with previous information cleared.
If at any point it asks you to save, select Save or Yes.
7) Reconnect the coaxial cable to the "Sat In" port on
back of receiver. Power on the antenna. Allow it 8 –10
minutes to acquire satellites.
Do not proceed to Step 8 until the antenna has
been completely silent for at least one minute.
8) Check that there are no checkmarks by SuperDISH or
Alternate. If setting up a DISH 311, 301, or 500 series
receiver, in some cases you may need to check the
boxes next to Superdish and Alternate before running
the Check Switch test.
9) Select Test again to install the SW64 switch. This SW64
switch is a DISH receiver setting, not a physical part.
When you see the SW64 as the
the antenna is ready for use.
DuraSAT D4 In-Motion Antenna
®
(cont.)
installed switch,
DISH Receiver Recommendations
®
The DuraSAT antenna will operate with most DISH
D4
®
receivers. Winegard does not recommend using receivers
with hard drives not recommended by the manufacturer for
mobile applications. Winegard recommends using a single
tuner DISH receiver. NOT compatible with dual-tuner DVRs.
DISH Satellite Coverage
®
The antenna will locate and toggle between satellites 110°,
119° and 129° in Western Arc Mode. The D4 antenna will
not operate in all areas where satellites 110°, 119° and 129°
are available.
Satellite coverage maps are based on level, stationary
operation. Reception interruption may also occur during
adverse weather conditions.
DISH satellites 110°, 119° & 129° coverage map
DISH satellite 110° &
D4 antenna coverage map
Coverage maps are for reference only and do not guarantee coverage.
119° DISH satellite 129°
D4 antenna coverage map
4