Dish ® Receiver Setup - Winegard DuraSAT D4 CM2000T Quick Start Manual

DIRECTV Receiver Setup
®
9) When the status bar reaches 100%, press Continue.
10) The receiver will run Data Feed and Guide Feed Tests
for a few moments.
When prompted to set up the remote, select
Setup Remote Later to do this at a later time.
Select Watch DIRECTV.
Receiver setup is now complete.
Receiver Recommendations
The DuraSAT antenna will operate with non-SWM receivers.
D4
®
Winegard does not recommend using receivers with hard
drives not recommended by the manufacturer for mobile
applications.
DIRECTV Satellite Coverage
®
The antenna will locate and toggle between satellites 101°
and 119°. The DuraSAT
D4
®
areas where satellites 101° and 119° are available.
The D4 antenna is not compatible with 110° or KA-band
satellites 99° and 103°.
Refer to the figure below for an operational coverage map of
satellite 101° and 119°.
Satellite coverage maps are based on level, stationary
operation. Reception interruption may also occur during
adverse weather conditions.
DIRECTV satellite 101° & 119° coverage map
DIRECTV satellite 101°
D4 antenna coverage map
3
(cont.)
antenna will not operate in all
Coverage maps are
for reference only
and do not guarantee
coverage.
DIRECTV satellite 119°
D4 antenna coverage map
DISH Receiver Setup
®
If using a DISH
antenna, the receiver must be configured off of
the primary port by following the steps below.
Receiver setup instructions are accurate at time of printing
and may change without notice. Call Winegard tech line for
assistance: 1-800-788-4417.
NOT COMPATIBLE with dual-tuner DVRs.
DISH ViP211z is the recommended model.
Check out online receiver setup guides for your
antenna at www.winegard.com/support. For
more information on receiver compatibility and
programming, visit www.winegard.com/receivers.
1) Before starting, disconnect the coax cable from the Satellite
In port on the back of the receiver.
Satellite "In" port
Back of 211z receiver shown
2) Press Menu on your remote. Select option 6; System Setup.
3) Select option 1; Installation.
4) Select option 1; Point Dish.
receiver with the DuraSAT
®
®
DuraSAT D4 In-Motion Antenna
®
D4