Specifications; Included Components; Replacement Parts - Winegard WAVU W1 Manual

SPECIFICATIONS

Antenna Type: Amplified
Range: Up to 35 miles*
Type: VHF and UHF channels
For Outdoor use Only
Omnidirectional
VHF/UHF/FM Antenna
Unit Weight: 2.11 lbs.
Antenna Head Diameter: 14.9"
Height of Antenna: 7.25"
Power required: +12VDC at 85mA
*Antenna reception may vary depending on the
height of the transmitting tower, lobe pattern of the
transmitter, height of the receiving antenna, weather
conditions, and any obstructions to the signal path.

INCLUDED COMPONENTS

Antenna Head
Attachment Tube
Wall Plate/Power Supply
Pedestal Top and Bottom
Surface Mount Box
5' Power Coaxial Cable
30' RG-59 Coaxial Cable

REPLACEMENT PARTS

Replacement head available by separate order.
Replacement power supply available by separate order.
FOR YOUR SAFETY
Do not install this system in rainy or wet
conditions. DO NOT PAINT this antenna.
Painting antenna will void antenna warranty.
INSTALLING SCREW-TYPE CONNECTORS
STEP 1. Strip off about 1/2" of the cable jacket.
STEP 2. Trim braid close to outer cover and
remove 1/4"* of inner insulation being careful not
to nick center conductor. Make sure no foil or
braid can touch center conductor.
STEP 3. Screw F-Connector onto cable end until
center conductor extends about 1/8" past the end
of the connector.
If installing in very hot weather, increase these
dimensions 1/8".
2
Circular Gasket
O-ring
Hexagonal Nut
Star Washer
Twist On F-Connector (4)
Insulated Terminal (2)
#6x3/4" Screw (2)
#6x1/2" Screw (2)
ANTENNA PARTS BREAKDOWN
Pedestal assembly
Wall plate/power supply
5' Power cable
30' RG-59 Coaxial
cable
Antenna head
Circular gasket
Attachment tube
Pedestal top
O-ring
Pedestal bottom
Star washer
Hexagonal nut
Surface mount box
Twist-on
#6 x ¾"
F-Connector
Screw (2)
(4)
#6 x ½"
Insulated
Terminal (2) Screw (2)