Status - Buffalo TS3210DN User Manual

Code
E22
E27
E30

Status

After you change settings or format a drive, the info LED will glow amber. You can also confirm the current status
from Settings or NAS Navigator2.
Code
I01
I10
I11
I12
I13
I14
I15
I16
I18
I19
I20
I21
I22
I25
I26
I27
I28
I31
Description
Unable to mount the drive.
Unable to find the backup TeraStation.
An error occurred, so the drive was
removed from the RAID array.
Description
Checking the system area.
A rise in the system temperature may have
exceeded the allowable safety value.
The drive has too many bad sectors.
Operating in degraded mode.
Formatting the RAID array.
Checking the RAID array.
Examining the error status of the RAID
array.
Note: Transfer speeds are slower during
the examination process.
Creating the RAID array.
Rebuilding the RAID array.
Note: Transfer speeds are slower during
the rebuilding process.
Rewriting the RAID array.
Formatting the drive.
Checking the drive.
Rewriting the drive.
Updating the TeraStation firmware.
Note: Do not turn off the power during the
updating process.
Initializing all settings.
Checking the USB drive.
Formatting the USB drive.
Displays when pressing the function
button to rebuild the RAID array after
replacing the drive.
Corrective Action
Format the drive. After formatting, if the
error still appears after rebooting, replace
the drive. If the error is displayed again,
contact Buffalo technical support for
assistance.
From the main TeraStation's Settings,
navigate to Backup > Failover to
reconfigure the backup TeraStation for
failover.
Replace the drive by referring to chapter 8,
"Drive Replacement".
Corrective Action
-
Move the TeraStation to a cool location. Do
not place objects in the area around the
TeraStation.
Replace the drive.
Check if the E30 message is also displayed.
In such a case, refer to the corrective action
for the E30 message.
-
-
-
-
-
-
-
-
-
-
-
-
-
Press the function button to rebuild the
RAID array.
201