Table of Contents
Advertisement
4
Select "Save current configuration to a USB drive".
5
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation, then click
Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The TeraStation will save the settings. When saving settings is finished, click OK.
Troubleshooting:
If the settings are not saved to the USB drive successfully, you may receive an error message such as "The specified
operation cannot be executed. " . Verify:
• The USB drive has a capacity of 1 GB or larger.
• The USB drive is not write-protected.
• Failover is configured on the TeraStation.
Applying Settings
The saved settings can be applied to a different TeraStation of the same series. If applying settings to another
TeraStation, the unit's current firmware version will be changed to the version used to save the settings.
Note: Since firmware version 3.03, saved settings cannot be applied from a USB drive which contains saved settings
from a unit that was running firmware version 3.00 or earlier. In such a case, create the settings restoration USB drive
again using the unit running firmware version 3.03 or later.
1
Insert the USB drive with the saved settings to a USB port on the TeraStation.
2
From Settings, click Management.
3
Click
to the right of "Configuration Management".
157
Advertisement
Table of Contents
