2
Click Backup.
3
Click
to the right of "Failover".
4
Click Configure Failover.
5
Click Force Failover to Stop to cancel the failover settings.
6
Shut down this main TeraStation.
7
Turn the backup TeraStation on.
8
Log in to Settings for the backup TeraStation, then rename the TeraStation's hostname and configure the IP
address so that it has a new static IP address.
9
Power on the main TeraStation. To configure the UPS sync on the backup TeraStation, configure the settings
here. Otherwise, skip to the next step.
To sync with the UPS device connected to the main TeraStation, follow the procedure below on the backup
TeraStation.
a. Click Management.
b. Click
to the right of "Power Management".
c. Click Edit.
d. Select "Sync with UPS connected to another Buffalo NAS device on the same network" and configure the
main TeraStation as a sync source.
e. Click OK when finished.
10
Reconfigure failover by referring to the "Configuring Failover" section above.
95