Table of Contents
Advertisement
2
Access the "usbdisk x" shared folder while connecting the USB drive to the TeraStation whose settings were
saved in the previous step. The "x" in the folder name represents the USB port number you connected the drive
to.
3
Copy and paste the .nas_config file to the desired location on your computer.
Transferring Settings
Follow the procedure below to transfer settings from another series TeraStation.
1
Before transferring access restrictions with Active Directory domain users, make sure the migration target
TeraStations are joined to the same domain controller. To have the unit join the domain network, refer to the
procedure on the "Active Directory" section in chapter 3.
If you didn't configure access restrictions with Active Directory domain users, skip to the next step.
2
From Settings, click Management.
3
Click
to the right of "Configuration Management".
4
Click Browse and choose the config file (.nas_config) that was created with another TeraStation. If the config
file was created with a password, enter it into the "Password" field.
5
Click Import.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The TeraStation will transfer the settings. When transferring settings is finished, click OK.
Notes:
• If the migration target TeraStation contains shared folders, users, and groups that share the same name as the
transferred settings, the existing settings will be overwritten.
• If the migration target TeraStations have already added some shared folders, users, and groups, the transferred
settings may exceed the maximum number of allowed shared folders, users, or groups. After migration finishes,
open Settings and verify that all settings were properly transferred.
159
Advertisement
Table of Contents
