NAS Navigator2 for macOS
NAS Navigator2 is a utility program that makes it easy to display Settings, change the Buffalo NAS device's IP
address, or check its drive. To install NAS Navigator2, download the installer from http://d.buffalo.jp/TS3010/.
Click the NAS Navigator2 icon (
Click a Buffalo NAS device's icon to display total capacity, used capacity, workgroup name, IP address, subnet mask,
default gateway, MAC address, and firmware version.
Double-click the icon to open a shared folder on the Buffalo NAS device.
Name
Open
Refresh
I'm here
Settings
Configure
Label Color
View Options
Auto Power Mode
To display these
options, hold down
the control key and
click your device's
icon.
) in the Dock to start NAS Navigator2.
Open Folder
Settings
Configure
I'm here
Label Color
Description
Opens the Buffalo NAS device's shared folders.
Searches for the Buffalo NAS devices on the network again.
Causes your Buffalo NAS device to beep.
Opens Settings for the Buffalo NAS device.
Opens the properties page that lets you configure the
Buffalo NAS device's IP address or open Settings.
Selects the color of the name displayed below the icon.
Lets you choose icon size, position, and view mode.
Auto power mode can turn supported Buffalo NAS devices
on the network on and off automatically.
Opens the Buffalo NAS device's shared folders.
Opens Settings for the Buffalo NAS device.
Opens the properties page that lets you configure the
Buffalo NAS device's IP address or open Settings.
Causes your Buffalo NAS device to beep.
Selects the color of the name displayed below the icon.
193