Errors And Status - Buffalo TeraStation WSS 5000 User Manual

LINK SPEED
Note: When an Ethernet cable is
connected to LAN Port 2, "LINK
SPEED 2" is displayed.
Disk Space Used
Hostname/IP Address
Calendar/Clock
Installed OS
IP Address 2

Errors and Status

LCD Message
SYSTEM Error E11
Fan Failure
SYSTEM Error E12
Cooling Failure
HDx Error E16
HDx Not Found
HDx Broken E30
Replace the DISK
LINK SPEED
No LINK
LINK SPEED
10Mbps
LINK SPEED
100Mbps
LINK SPEED
1000Mbps
HDD
USED
WS5000xxx
192.168.11.150
DATE TIME
2012/1/1 11:11
Windows Storage Server
2012
NETWORK2
192.168.11.151
Description
An error occurred in the fan speed.
A rise in the system temperature may have
exceeded the allowable safety value.
Unable to find hard drive X.
An error occurred, so hard drive X was
removed from the RAID array.
Not connected to network.
Connected at 10 Mbps.
Connected at 100 Mbps.
Connected at 1000 Mbps full duplex.
Bar graphs are shown to indicate the used
space for the C, D, E, and F internal drives of
the TeraStation. When a hard drive is full, it is
indicated by "^".
Displays the hostname and IP address.
Displays the date and time set in the
TeraStation.
Displays the OS installed on the TeraStation.
Displays the IP address of LAN port 2 when
an Ethernet cable is connected to LAN port 2.
Corrective Action
Check that no foreign
objects or dust are
clogging the fan. If any
foreign objects or dust
are found, use a pair of
tweezers, air duster, or
other tool to remove
them. If the error is
displayed again, contact
Buffalo technical support
for assistance.
Do not place objects
in the area around the
TeraStation. Also, move
the TeraStation to a cool
location. Make sure that
the TeraStation's fan is
working normally.
Hard drive X may be
disconnected or may
have failed. After shutting
down, reinstall the hard
drive.
Replace hard drive X.
60