Using A Redundant Raid Mode And Terastation Is Off; Using Raid 0 - Buffalo TS3210DN User Manual

The TeraStation will start rebuilding the RAID array automatically. After a few minutes, the I18 message will be
displayed until the array is rebuilt.
For JBOD:
The drive will be formatted as an individual drive. Create a shared folder on the drive before use.

Using a Redundant RAID Mode and TeraStation Is Off

1
Open the front cover with the included key.
2
The failed drive's status LED will be glowing red. Push its unlock button and swing the lock mechanism out.
3
Pull out the drive cartridge and remove it from the TeraStation.
4
Insert the new drive into the empty slot. Slide the drive in with the locking mechanism open.
5
Swing the lock back down until it clicks into place.
6
Close the front cover.
7
Press the power button on the TeraStation.
8
When the replaced drive is recognized, the status LED will flash red and the I31 message will appear in Settings
or NAS Navigator2.
9
Press the function button on the front of the TeraStation. The TeraStation will beep. If replacing multiple
malfunctioning drives at once, select the replaced drives on Settings and click Recover RAID Array.
10
The TeraStation will start rebuilding the RAID array automatically. It will take about 5 minutes before the I18
message is displayed.

Using RAID 0

Drives in a RAID 0 array do not automatically turn off in the event of a malfunction. Shut down the TeraStation
before replacing the failed drive.
This section describes the process of replacing a drive with
Note: If a drive malfunctions in RAID 0, all data on the RAID array will be lost. All of the settings for the shared folders
(such as access restrictions) are erased after replacing a drive from a RAID 0 array.
1
Turn off the TeraStation.
2
Open the front cover with the included key.
3
The failed drive's status LED will be blinking red. Push its unlock button and swing the lock mechanism out.
4
Pull out the drive cartridge and remove it from the TeraStation.
5
Insert the new drive into the empty slot. Slide the drive in with the locking mechanism open.
6
Swing the lock back down until it clicks into place.
7
Close the front cover.
8
Press the power button on the TeraStation.
the TeraStation off.
186