Figure 15. Scsi Termination Examples For The Desktop Lto-1 And Lto-2 Tape Drives - Certance LTO 1 User Manual

Installation (and Quick Start)
Connecting a SCSI Cable
The desktop LTO-1 and LTO-2 drives have two 68-pin, shielded SCSI interface connectors (ANSI
Alternative 2) on the rear panel (see Figure 14 on page 28). These connectors consist of two rows of
ribbon contacts spaced 2.16 mm (0.085 in) apart. Either connector can be used as a SCSI IN or
SCSI OUT connection. This means you can use either connector to attach the drive to a host com-
puter or to another SCSI device.
1. Turn off all power to the drive and the computer.
2. Attach the SCSI interface cable to one of the 68-pin SCSI interface connectors on the back of
the drive (see Figure 14 on page 28).
Checking the SCSI Termination
If the desktop LTO-1 or LTO-2 drive is the last or only device in a SCSI chain, install a terminating
plug on the unused SCSI connector. See Figure 15 on page 29 for two SCSI termination examples.
You can purchase appropriate terminating plugs on the Internet at http://shop.certance.com (U.S.
only).
NOTE: Termination power is enabled as a default for desktop drives.
External
Tape Drive
External
SCSI device
SCSI Controller
(termination enabled)
Example 1: SCSI termination
in a system that has only
external SCSI devices.

Figure 15. SCSI Termination Examples for the Desktop LTO-1 and LTO-2 Tape Drives

SCSI Terminators
Example 2: SCSI termination
in a system that has both
internal and external SCSI
devices.
Installing a Desktop Drive
External
SCSI device
External
Tape Drive
SCSI Controller
(termination disabled)
Internal
SCSI device
( termination
enabled )
29