Figure 25. Underside Of Lto-1 And Lto-2 Drives Showing Supply Motor Access Hole - Certance LTO 1 User Manual

Quantum lto 1: user guide

Hide thumbs Also See for LTO 1:

Table of Contents

Troubleshooting Guide

Figure 25. Underside of LTO-1 and LTO-2 Drives Showing Supply Motor Access Hole

When all of the tape has been spooled off of the take-up reel, turn the drive right side up.

Rotate the hub to align the slot in the hub with the slot on the drive chassis (see Figure 23 on

page 79).

Set the drive on its left side. Rotate the load arm until the tape grabber clears the hub.

CAUTION: Be especially careful not to touch the tape head assembly. The MR elements in this

assembly are highly susceptible to damage from static electricity.

Take up the slack tape again using the 1.5-mm hex wrench, as described in step 4.

Carefully push the grabber in toward the cartridge, as shown in Figure 26 on page 82.

Manually Removing a Cartridge

Table of Contents

Table of Contents

Lto 2