Table 1. Scsi Ids And Jumper Settings For Lto-1 And Lto-2 Drives; Terminator Power - Certance LTO 1 User Manual

Installation (and Quick Start)

Table 1. SCSI IDs and Jumper Settings for LTO-1 and LTO-2 Drives

SCSI ID
0
1
2
3
4
5
6 (default)
8
9
10
11
12
13
14
15

Terminator Power

By default, terminator power is disabled on internal LTO-1 and LTO-2 tape drives. To enable termina-
tor power, place a jumper across pins 11 and 12.
NOTE: The internal LTO-1 and LTO-2 drives do not provide SCSI termination. Thus, a terminator
must be installed on the drive if it is the last device in a SCSI chain.
Jumpers
1–2 3–4 5–6
Open Open Open
Shunted Open Open
Open Shunted Open
Shunted Shunted Open
Open Open Shunted
Shunted Open Shunted
Open Shunted Shunted
Open Open Open
Shunted Open Open
Open Shunted Open
Shunted Shunted Open
Open Open Shunted
Shunted Open Shunted
Open Shunted Shunted
Shunted Shunted Shunted
Installing an Internal LTO-1 or LTO-2 Drive
7–8
Open
Open
Open
Open
Open
Open
Open
Shunted
Shunted
Shunted
Shunted
Shunted
Shunted
Shunted
Shunted
18