Figure 4. Acceptable Mounting Orientations; Figure 5. Internal Lto-1 And Lto-2 Drive Mounting Dimensions; Mounting An Internal Hvd Or Lvd Drive - Certance LTO 1 User Manual

Installation (and Quick Start)

Mounting an Internal HVD or LVD Drive

You can mount the internal LTO-1 and LTO-2 drives either horizontally or vertically, with the drives left
side facing up (see Figure 4 on page 19).
If you mount the drive vertically, the left side of the drive must face up and the side of the drive
•
should be within 5 degrees of horizontal.
If you mount the drive horizontally, the base of the drive must be within 15 degrees of horizon-
•
tal and the PCB side of the drive must face down.

Figure 4. Acceptable Mounting Orientations

Mount the drive in a 5.25-inch, full-height drive bay and secure it using two M3.0 X 5 metric screws
on each side of the drive. Do not use screws longer than 5 mm or you may damage the drive.
Figure 5 on page 19 shows the locations of the mounting-screw holes on the side and bottom of the
drive, respectively.

Figure 5. Internal LTO-1 and LTO-2 Drive Mounting Dimensions

Installing an Internal LTO-1 or LTO-2 Drive
19