Table of Contents
Advertisement
DVR User Manual
Device Management
Click "Edit Recipient" to go to the following interface.
Click "Add" and then enter the recipient's e-mail address and select the schedule (if a schedule is selected, the system will send the alarm email
and the recipient will receive it only in the selected schedule time) in the popup window. Click "Add" in the window to add the recipient. You can
also change the recipient's receiving schedule by clicking
in the "Schedule" column. Click
to delete the recipient in the list. Click "Apply"
to save the settings. Click "Edit Sender" to go to the e-mail configuration interface of the sender.
11.1.6 UPnP Configuration
By UPnP you can access the DVR through the web client which is in WAN via router without port mapping.
① Click StartSettingsNetworkUPnP to go to the following interface.
② Make sure the router supports UPnP function and the UPnP is enabled in the router.
③ Set the DVR's IP address, subnet mask and gateway and so on corresponding to the router.
④ Check "Enable" in the interface as shown below and then click "Apply" button.
Click "Refresh" button to refresh the UPnP status. If the UPnP status says "Invalid UPnP" after refreshing it a few times, the port number may be
wrong. Please change the mapping type to "Manual" and then click
to modify the port until the UPnP status turns to "Valid UPnP". Refer to
the following picture. You can view the external IP address of the DVR. Enter the external IP address plus port in the address bar of your browser to
access the DVR such as http://183.17.254.19:81.
73
Advertisement
Table of Contents
