Basic Operation Guide; Startup & Shutdown; Startup; Shutdown - Speco H16HRL User Manual

Basic Operation Guide

2.1 Startup & Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper startup and shutdown are crucial to extending the
life of your device.

2.1.1 Startup

① Connect the output display device to the VGA/HDMI interface of the DVR.
② Connect with the mouse and power. The device will boot and the power LED would turn blue.
③ EZ setup window will pop up (you should select the display language the first time you use the DVR). Refer to 3.1 EZ Setup for details.

2.1.2 Shutdown

You can power off the device by using remote control or mouse.
By remote control:
① Press Power button. This will take you to a shutdown window. The unit will power off after a while by clicking the "OK" button.
② Disconnect the power.
By mouse:
① Click StartShutdown to pop up the Shutdown window. Select "Shutdown" in the window. The unit will power off after a while by clicking the
"OK" button.
② Disconnect the power.

2.2 Remote Control

① It uses two AAA size batteries.
② Open the battery cover of the remote control.
③ When adding batteries check for the polarity (+ and -).
④ Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
If it still doesn't work, please contact your distributor or tech support. You can just turn the IR sensor of the remote control towards the IR receiver
of the DVR to control it when you are controlling multiple devices by remote control.
The interface of remote controller is shown as below.
2 Basic Operation Guide
5
DVR User Manual