Table of Contents
Advertisement
Chapter 2 Operating the Library
Using the Control Panel Menus
Setting a Tape
Drive SCSI
2
Address
Table 2 Default Tape
Drive SCSI Address
30
Exit the menu mode.
8
After changing the SCSI address of the library, one of
Note:
two things must happen to set the new SCSI ID: the
host controller must issue a "SCSI Bus Reset," or the
library must be powered off and on again.
The SCSI Address/ Drive function is used to set the SCSI address
of tape drives in the library. The library ships with the tape drives
configured as shown in
SCSI Address
1
2
3
4
5
6
1 (second bus)
SCSI address 7 is typically reserved for the host
Note:
controller.
To change the SCSI addresses of the drives in the library:
Enter the menu mode.
1
Quantum|ATL 7100 Series Library Operator's Guide
table
2.
Drive Number
0
1
2
3
4
5
6
Physical Location
top drive
second drive
third drive
fourth drive
fifth drive
sixth drive
bottom drive
Advertisement
Table of Contents
