Load Port - Quantum ATL 7100 Operator's Manual

Chapter 1 Introduction
Operator Accessible Components
Control
FAULT
(Indicator)
Status Display
Area
1

Load Port

8
Library Function
The FAULT indicator illuminates when the library has an error condition.
The SDA displays the name of the error condition. For a listing and
detailed description of all status messages shown in the SDA, see chapter
3, Operator Troubleshooting.
This is a 16-character, 2-line liquid crystal display (LCD) display. It
displays status messages that describe the operating state of the library. It
also displays menu options when the library is in menu mode.
The load port is located at the front of the library above and to the
left of the control panel (see
and/or remove up to four tape cartridges (see
description of the load port buttons).
To load/remove cartridges, press the
indicator stops blinking, the load port door opens and allowing the
operator to insert tape cartridges. To close, press the
and push the door to the closed position.
You must release the
Caution:
the load port door closed.
For the unload operation, the gripper places tape cartridges in the
load port bins. Looking through the view port, the operator will be
able to decide if an unload operation is necessary. Pressing the
button automatically opens the door allowing the operator
OPEN
to remove the tape cartridge(s).
Quantum|ATL 7100 Series Library Operator's Guide
figure 1). It allows an operator to insert
table 1
button. When the
OPEN
button before pushing
CLOSE
for a
button
CLOSE