Module Programming For Convenience Only (Skip Transponder) - Directed DIRECTWIRE DIRECTECHS THGMN4 Installation Manual

Module programming for convenience features only (skip transponder programming)
Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
Ensure vehicle is in a safe location and cannot move forward during programming. For vehicles
1
equipped with a manual transmission, make sure the gearshift is in the neutral position.
Connect the 12-pin main power harness to the module.
2
DS3+: Wait until the LED turns ON solid red then connect remaining harnesses to the module.
DS4+: The LED turns ON solid blue for 1 second to confirm Bluetooth communication. Wait until
the LED turns ON solid red, then connect remaining harnesses to the module.
Enter the vehicle while making sure the factory remote is inside with you.
3
Press the programming button five (5) times.
The LED turns ON solid orange.
Press and hold the Push-to-Start (PTS) button until the ignition turns ON.
4
The LED flashes orange then turns ON solid orange for 3 seconds then shuts OFF.
5
Press once (1) more on the PTS button to turn the ignition OFF.
Pair remotes (if applicable).
6
For information on how to pair a specific remote, please refer to its corresponding owner
documentation, which can be found inside the product packaging of the complete system or on
www.directechs.com. Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
17
933.GM9 2.46.198.9 2022 Chevrolet Equinox (Smart Key)
©2023 Directed. All rights
DS3+ DS4+
10 12 22 8
OR
Must connect 2 4 4 4 2
Solid Solid Solid
12-pin FIRST
1 Sec
Key
Solid
Press &
Inside
Release x5
Flashes Solid Off
x 3 sec
AFTERMARKET
Pair
remotes