Directed DIRECTECHS DS4+ Installation Manual
  1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. DS4+
  6. Installation manual
Directed DIRECTECHS DS4+ Installation Manual

Directed DIRECTECHS DS4+ Installation Manual

Hide thumbs Also See for DIRECTECHS DS4+:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION GUIDE
CHRYSLER12
Designed by Installers for Installers
© 2017 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
2017-11-15
DS4+

Advertisement

Table of Contents
loading

Related Manuals for Directed DIRECTECHS DS4+

Summary of Contents for Directed DIRECTECHS DS4+

  • Page 1 CHRYSLER12 Designed by Installers for Installers © 2017 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.

  • Page 2: Table Of Contents

    Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main harness (H1), 12-pin black connector .................. 6 Relay harness (H2), 10-pin white connector .................. 6 Data harness (H3), 8-pin white connector ..................

  • Page 3: Warning! Safety First

    The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.

  • Page 4: Introduction

    The Green wire is ONLY required for starter kill and anti-grind connections. Additional parts required (maximum required): Resistor 100Ω Fuse 7.5A Diode 6A 2 x 1K Ω Resistor 0 x 1A Diodes 0 x Fuse 0 x Relay DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 5: Vehicle Application Guide

    • • • • • Legend: DL: OE Door Lock & Alarm Controls PK: Transponder & Immobilizer Override RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 6: Wiring Connections

    (MUX) Analog Input/Output H3/7 Orange/Black ISO BUS 2 H3/8 Yellow/Black ISO BUS 1 If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 7: Analog Input/Output Harness (H4), 22-Pin White Connector

    If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 8: Installation (Wiring Diagrams, Fuse Selection & Vehicle Wiring Reference Charts)

    It is important to check that the Gray, pin 1 (+) Ignition 2: Orange, pin 1 fuses are positioned correctly. (+) Ignition 1: Dk.Blue, pin 2 White 3-pin conn. White 3-pin conn. (at ignition switch) (at ignition switch) DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 9 Ignition 1 Dk.Blue Ignition switch. White Accessory Gray Ignition switch. White Key Release Brown/Orange At key cylinder. White Parking Lights Yellow/Black Headlight switch. Gray Black & Door Locks Violet/Red BCM/dash fuse box. Blue DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 10: Type 2

    (+) Ignition 2 Output: (+) Starter: Brown, pin 3 fuses are positioned correctly. Orange, pin 1 Key Release Switch (at key cylinder) Black 2-pin conn. White 3-pin conn. (at ignition switch) (at ignition switch) DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 11 Accessory Ignition switch. Black Gray Key Release Brown/Orange At key cylinder. White Parking Lights Lt.Green/Black Steering column harness. Brown Door Locks Violet/Red BCM/dash fusebox. Green Rear Door/Trunk Unlock Gray/White BCM/dash fusebox. Green DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 12: Type 3

    It is important to check that the (+) Ignition 2 Output: Brown/White or fuses are positioned correctly. White/Black, pin 1 Brown Gray, pin 3 White 3-pin conn. White 3-pin conn. (at ignition switch) (at ignition switch) DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 13 At key cylinder White Parking Lights Yellow/Black Headlight switch. Black Door Locks Blue/Yellow BCM/Dash fuse box. Green Rear Door/Trunk Unlock Gray/White BCM/Dash fuse box. Green Drivers Door Trigger White/Violet BCM/Dash fuse box. Green DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 14: Type 4

    (+) Ignition 2 Output: (+) Accessory: Blue, pin 1 White/Black, pin 1 It is important to check that the fuses are positioned correctly. White 3-pin conn. White 3-pin conn. (at ignition switch) (at ignition switch) DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 15 Parking Lights Yellow/Black Headlight switch. Black Door Locks Blue/Yellow BCM/Dash fusebox. Green Rear Door/Trunk Unlock Gray/White BCM/Dash fusebox. Green Drivers Door Trigger White/Violet BCM/Dash fusebox. Green Brake Green/White Brake pedal switch. White DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 16: Type 5

    (+) Ignition 2: fuses are positioned correctly. White/Red, pin 3 Orange, pin 1 Key Release Switch (white conn. at key cylinder) Black 3-pin conn. Black 2-pin conn. (at ignition switch) (at ignition switch) DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 17 At key cylinder. White Parking Lights Green/Black Connector at headlight switch. Black Door Locks Violet/Red BCM/Dash fusebox. Black Rear Door/Trunk Unlock Violet/Blue BCM/Dash fusebox. Black Drivers Door Trigger White/Violet BCM/Dash fusebox. Black DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 18: Key2Go

    Any first-time user must re-register to gain access to Key2GO, and some additional information will be required to complete the registration process, such as your Directed account number and store name. Key2GO is compatible with XKLoader2, the online web tool, and the DirectLink Mobile application.

  • Page 19: When Used In Conjunction With Smartstart

    START START START START START START Note: If transponder programming was skipped, the LED turns ON solid & up to x 10 Flashes orange orange for 3 seconds then shuts OFF. slowly DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 20 By default, the tachometer is preprogrammed for the vehicle. For instructions on how to Initialize tachometer program tach, see page 24. * Your aftermarket remote may differ from the model shown in the illustrations. You have successfully completed the module programming sequence. DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 21: Led Diagnostics And Troubleshooting

    External module synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.
  • Page 22 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 23: Soft Reset

    After 3 seconds the LED turns ON solid orange. Keep holding the programming button until & & the LED flashes red, then orange slowly. Solid Hold Flashes Release the programming button. The LED turns ON solid red. & Release Solid DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 24: Learning The Tach (Not Needed With Virtual Tach)

    Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature using the DirectLink application for mobile devices to adjust the starter output time in 50mS increments to compensate for such an occurrence. DS4+ CHRYSLER12 © 2017-11-15 Directed. All rights reserved.

  • Page 25: Limited Lifetime Consumer Warranty

    Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...

  • Page 26: Quick Reference Guide

    Factory remote. Press the Remote Start button on the transmitter.* • Aftermarket remote. • Directed SmartStart application via your smartphone. & The parking lights will flash once to indicate the Parking lights flash x1 Press Remote vehicle is now in Pit Stop Mode.
  • Page 27 The application enables a “Cloud-Connected Car” like never before, providing 2-way interaction with your vehicle. Connectivity is managed through the Directed Cloud Services (DCS) network linking car, app, end user, and the Internet.

Table of Contents