Sound Mode; Manual Color; Master/Slave Mode; Linking - ProLights Lumipix9HE User Manual

• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 SOUND MODE

In music mode, the LUMIPIX9HE can be controlled by music with a clear rhythm in the bass range. If the
music control should not work optimally, increase the volume or reduce the distance of the sound source.
• Press the button MENU so many times until the display shows Snd.
• Press the button ENTER to confirm.
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
Sens.
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) u0 - u100.
• Press the button ENTER to confirm.

3.7 MANUAL COLOR

This mode allows to combine the colors red, green, blue amber white and purple (r, g, b, a, W, P).
• Press the button MENU so many times until the display shows [U--], then press the button ENTER.
• Select the color r, g, b, a, W, P through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.8 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Use any one of the standalone modes for the master unit.
• Set the slaves to the same DMX modes.

3.9 LINKING

1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.10 DMX MODE

• Press the button MENU so many times until shows, 6 CH, 9CH, 11CH, 18 CH or 23 CH and press the button
ENTER to confirm.
• Press the button UP/DOWN to select the desired DMX address d1 - d512. Press and hold to scroll quickly.
Press ENTER button to store.
The tables on page 14 indicate the operating mode and DMX value. The LUMIPIX9HE is equipped with 3
pole XLR connections.
LUMIPIX9HE
11