Power Supply - Videx ESVK/6488 Series Manual

ESVK/6488 Series "2 wire Bus" videokit
Art. 4042 .. 4045
Art. 4042D .. 4045D

POWER SUPPLY

To give power supply to the module
connect one of the inbuilt IDC male
connector to the IDC male connector
I
of the camera unit module through the
flat cable provided. A further buttons
expansion module can be connected to
the free IDC male connector of the pre-
vious expansion module (Fig. 3).
SW1 SETTINGS
Left position = TRADE
Trade button connection related to push button
no.1 (only if SW1 is swithed on Trade side).
SW1
J2 AND J1 BACKLIT LEDS SETTINGS
USING WITH ART. 4284, ART. 4284X OR ART. 4533
(DEFAULT SETTING)
J2
B A
USING WITH ART. 4384 OR ART. 4384X AND ONE SINGLE
EXPANSION BUTTON MODULE
J2
B A
HOW TO REMOVE/INSERT THE CARD NAME HOLDER
• To avoid damage to the module front plate, mask the side that
will be in contact with the screwdriver blade;
• Insert the screwdriver (flat side) into the card-holder hole as
shown in Fig. 4;
• Move the screwdriver to the left as shown in Fig. 5 to extract
the card name holder;
• Edit the card name then replace it inside the holder and refit:
insert the holder inside its housing from the left or right side
then push the other side until it clips into place.
ESVK/6488 Series - Installation handbook
Single row button expansion modules
Double row button expansion modules
Art. CFL17
17 cm lenght flat cable
(Supplied)
Art. CFL45
45 cm lenght flat cable
(to be ordered separately)
Fig. 3
J1
B A
J1
B A
Right position = STANDARD
Standard matrix call buttons (default).
SW1
USING WITH ART. 4384 OR ART. 4384X AND A COUPLE
EXPANSION BUTTON MODULES
Art. 4384 - Art. 4384X
Expansion button module 1
J2
B A
Expansion button module 2
J2
B A
NOTE: to connect more than 2 expansion button modules,
please refer also to the installation diagrams.
Fig. 4
- 31 -
OR
J1
B A
J1
B A
Fig. 5
66550031-EN - V6.1 - 15/08/20
1
2