Main Features - Videx ESVK/6488 Series Manual

ESVK/6488 Series "2 wire Bus" videokit
Art. 4901
Digital codelock module
A
Fig. 1 Front
DESCRIPTION
The Art.4901 is manufactured from 316 grade brushed stainless
steel and the module features 12 stainless steel buttons, backlit
in blue (Keys 0 - 9, ENTER and CLEAR) and 2 LED's for progress
information during use and programming. With three integral
relays each with common, normally open and normally closed connections and two inputs to enable the external triggering of
relays one and two (for example, push to exit button). Key presses are signalled both acoustically and visually while each button
press has a tactile feel. Entering the correct code followed by ENTER will activate the relevant relay. Programming is carried out
through the same keypad following a simple programming menu. The module can be combined with other 4000 Series modules in
an audio or video intercom system.

MAIN FEATURES

• 3 C, NC, NO relay outputs (24Vac/dc – 5A max);
• 3 Programmable secret codes (one for each relay);
• Each relay can be set to be activated for a specific time (01 to 99 seconds) or to work as latch;
• Two active low inputs to command directly the relay 1 and 2;
• Programming menu guarded by a 4-8 digit programmable engineer's code;
• Visual and Acoustic signal during operating and programming;
• Keypad illumination LEDs;
GENERAL DIRECTIONS FOR INSTALLATION
In order to achieve the best results from the schematics described it is necessary to install only original VIDEX equipment, strictly
keeping to the items indicated on each schematic and follow these General Directions for Installation:
• The system must be installed according to national rules in force, in any case the running of cables of any intercom unit must be
carried out separately from the mains;
• All multipair cables should be compliant to CW1308 specification (0.5mm twisted pair telephone cable).
• Cables for speech line and service should have a max resistance of 10 Ohm
• Lock release wires should be doubled up (Lock release wires and power supply wires should have a max resistance of 3 Ohm);
• The cable sizes above can be used for distances up to 50m. On distances above 50m the cable sizes should be increased to keep
the overall resistance of the cable below the RESISTANCES indicated above;
• Double check the connections before power up;
• Power up the system then check all functions.
ESVK/6488 Series - Installation handbook
B
4901
STEEL
ALI
HIGH BRASS
MATTE
C
D
Fig. 2 Back
LEGEND
Green LED
A
Red LED
B
Backlit keypad
C
- 17 -
Made in Italy
Note: Remove MOV
jumper completely
when using a relay to
trigger a gate controller.
A
JPL
B
F
JPL jumper
D
MOV jumpers
E
Connection terminals
F
66550031-EN - V6.1 - 15/08/20
Rev.0.1
E