Wall Mounting Instructions - Videx ESVK/6488 Series Manual

ESVK/6488 Series "2 wire Bus" videokit
6400 Series
A
2
1
A
Fig. 1
C
B
D
G
G
Fig. 4
2
Fig. 7
1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base:
insert a 5.5mm flat screw driver into the clip
Repeat the same operation with the other clip as shown in Fig. 1.
2. Pull outwards the left part of the cover as shown in Fig. 2. Don't pull the cover straight.
3. Put the base of the unit on the wall at approx 135cm from the finished floor (Fig. 3) to match the points for the fixing holes
(Fig. 4) remembering that the wires
503, embed it into the wall vertically at approx. 140cm from the finished floor and the base.
4. Following Fig. 4, make the holes
the hole F . If you have used the box 503, fix the base to the wall through the holes
5. As shown in Fig. 5, connect the wires to the removable terminals following the provided installation diagram. Connect the terminal
blocks to the electronics contained in the cover as shown in Fig. 6. Test system before closing.
Contrast and hue trimmers can be adjusted only if the videophone is open. To activate the display and see changes use the
"Camera Recall" function by pressing
Note: while testing the system, it is advisable to hold the cover with your hand.
6. Once testing is complete and all the necessary adjustments are made, close the unit as shown in Fig. 7: first hook in the right
part and then the left part until you hear a "CLICK!".
ESVK/6488 Series - Installation handbook

Wall mounting instructions

Fig. 2
E
C
B
D
Fig. 5
1
A
E (Fig. 4) must be fed through the large hole
B
, insert the wall plugs
button.
then rotate clockwise until you listen a "CLICK!".
C
and fix the base with the screws
- 27 -
Fig. 3
Fig. 6
F (Fig. 4). If you use the flush mounting box
D
feeding the wires
G using the screws D .
66550031-EN - V6.1 - 15/08/20
B
E
through