Beckhoff KS31 2 Series Manual page 37

Configuration Software KS2000
Siemens output format (R32.4 [} 50])
You can activate Siemens output format here (default: deactivated).
Calibration active (R32.5 [} 50])
You can deactivate the calibration here (default: activated).
Differential measurement (R32.6 [} 50])
You can deactivate the differential measurement here (default: activated).
Stabilization of calibration active (R32.7 [} 50])
You can deactivate the stabilization of the calibration here (default: activated).
Limitation of the measuring range active (R32.8 [} 50])
You can deactivate the limitation of the measuring range here (default: activated).
Limit value 1 active (R32.9 [} 50])
You can activate the limit value 1 here (default: deactivated).
Limit value 2 active (R32.10 [} 50])
You can activate the limit value 2 here (default: deactivated).
Register values
User offset (R33 [} 52])
You can specify the user offset between -32768 and 32767 here (default: 0).
User gain (R34 [} 52])
You can specify the user gain between 0 and 65535 here (default: 256, corresponding to a factor of 1).
Calibration interval (R40 [} 53])
You can specify the calibration interval for the reference signal here in steps of 100 ms (default: 300 s).
Forced calibration interval (R44 [} 53])
You can specify the interval for the forced calibration here. This interval is always a multiple (default: 3 ) of
dez
the calibration interval. The interval for forced calibration when the terminal leaves the factory is therefore
3 x 180 s = 900 s.
Number of stable measured values (R47 [} 53])
You can specify the number of measured values used for the calibration here (default: 50).
Tolerance for measured value stability (R48 [} 53])
You can specify the stable measured value tolerance for the calibration here (default: 5).
Limit value 1 (R35 [} 52])
You can specify the limit value 1 here (default: 0).
KL31x2/KS31x2 Version: 2.6.0 37