Beckhoff KS31 2 Series Manual page 50

Data structures
R19: Manufacturer scaling - offset:
This register contains the offset of the manufacturer scaling. Can be activated via R32.1 [} 50] in the feature
register (16 bit signed integer).
R20: Manufacturer scaling - gain:
This register contains the gain of the manufacturer scaling. Can be activated via R32.1 [} 50] in the feature
register (16 bit unsigned integer x 2-
0x0100 means factor 1.
0x0080 means factor 0.5
R21: Upper measuring range limit
This register contains the upper measuring range limit. It can be activated by R32.8 [} 50] in the feature
register.
R22: Lower measuring range limit
This register contains the lower measuring range limit. It can be activated by R32.8 [} 50] in the feature
register.
R23: Reference calibration value: Offset
This register contains the reference value of the calibration, which is determined during the vendor
calibration.
R24: Reference calibration value: Gain
This register contains the reference value of the calibration, which is determined during the vendor
calibration.
R31: Code word register
• If you write values into the user registers without first entering the user code word (0x1235) into the
code word register, the terminal will not accept the supplied data.
• If you write values into the user registers and have previously entered the user code word (0x1235) in
the code word register, these values are stored in the RAM registers and in the SEEPROM registers
and are therefore retained if the terminal is restarted.
The code word is reset if the terminal is restarted.
R32: Feature register
The feature register specifies the terminal's configuration.
Bit R32.15 R32.14
Name Callibration Display
Display StabilityError
Bit R32.7 R32.6
Name enStable disDiff
Measure
50
8
+ 1). Examples:
R32.13 R32.12
- -
R32.5 R32.4
disCali enSiemens
Format
Version: 2.6.0
R32.11 R32.10
disChannel enTh2
R32.3 R32.2
enAverage disWd
Format Timer
R32.9 R32.8
enTh1 enOverProt
R32.1 R32.0
enManScal enUsrScal
KL31x2/KS31x2