Page 1
SD 5000-A22 Deutsch English Français Italiano Español Português Nederlands Dansk Svenska Norsk Suomi Ελληνικά Magyar Polski Русский Česky Slovenčina Hrvatski Slovenščina Български Română Türkçe ﻲ ﺑ ﺮ ﻋ Latviešu Lietuvių Eesti 日本語 한국어...
Page 6
• Make a note of the designation and serial number printed on the identification plate in the following table. ▶ Always quote this information when you contact a Hilti representative or Hilti Service to enquire about the product.
Page 7
Product information Type: Generation: Serial number: 2 Safety 2.1 Safety instructions The safety instructions listed in the following section include all general safety instructions for power tools which, in accordance with the applicable standards, require to be listed in the operating instructions. Accordingly, some of the instructions listed may not be relevant to this power tool.
Page 8
▶ If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. Power tool use and care ▶ Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed.
Page 9
Accordingly, use a suitable vacuum cleaner of the type recommended by Hilti for wood dust and/or mineral dust and which is designed for use with this power tool. Ensure that the workplace is well ventilated. Observe national regulations applicable to the materials you intend to work with.
Page 10
3.4 Items supplied Drywall screwdriver, depth gauge, bit, bit holder, operating instructions Note You can find other system products approved for use with your product at your local Hilti Center or online at: www.hilti.com. 3.5 Depth gauge The depth gauge is attached to the screwdriver by way of a snap-on connection and can be simply pulled off or pushed on.
Page 11
3.9 Belt hook Using the belt hook, the drywall screwdriver can be carried conveniently, close to the body, on a belt. The belt hook can be fitted to allow attachment on the left or right side of the body. 3.10 Universal hook The universal hook allows the screwdriver to be put aside or stored temporarily in a number of different ways.
Page 12
5.2 Inserting the battery WARNING Risk of injury! Inadvertent starting of the screwdriver. ▶ Before fitting the battery, check that the screwdriver is switched off and that the forward / reverse switch is in the middle position (i.e. safety lock engaged). WARNING Risk of injury! Hazard presented by a falling battery.
Page 13
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare parts, consumables and accessories approved by Hilti for use with the product can be found at your local Hilti Center or online at: www.hilti.com...
8 Troubleshooting Note If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by yourself, please contact Hilti Service. Trouble or fault Possible cause Action to be taken The screwdriver doesn’t...
Page 15
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, your old tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
Page 16
Technical documentation filed at: • Electric Tools Approval Department Hilti Entwicklungsgesellschaft mbH Hiltistraße 6 86916 Kaufering Germany Schaan, 12/2015 Gunnar Wald Lars Taenzer (Head of Quality, Business Unit Installation Systems) (Head of BU Direct Fastening)