In these operating instructions, the designation “power tool” always refers to the SFC 22-A or SFC 14-A cordless Always keep these operating instructions to- drill / driver with battery fitted. gether with the power tool.
Symbols number on the side of the casing. Make a note of this data in your operating instructions and always refer to it when making an enquiry to your Hilti representative or service department. Type: Direct Rated speed Revolutions Drilling...
Page 7
2.1.4 Power tool use and care 2.2 Drill safety warnings a) Do not force the power tool. Use the correct a) Wear ear protectors when impact drilling. Expos- power tool for your application. The correct power ure to noise can cause hearing loss. tool will do the job better and safer at the rate for b) Use auxiliary handle(s), if supplied with the tool.
Operating instructions NOTE Approved accessories are available from your Hilti Center or can be ordered online at www.hilti.com. 3.3 Additional items required for operating the tool: A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from the C 4⁄36 series.
Fire hazard. Never transport batteries in loose, bulk form. is switched off and that the safety lock is engaged There is a risk of short circuiting. (forward/reverse switch in the middle position). Use only the Hilti batteries approved for use with this power tool.
5.5 Belt hook 4 Pull the battery out of the locked position (working posi- tion) and move it into the first latching position (transport CAUTION position). Check that the belt hook is fitted securely before Observe national and international transport regulations beginning work.
- If use continues, further battery discharge will be not use a spray, steam pressure cleaning equipment or stopped automatically before the battery cells suffer damage. - Charge the batteries using the specified and approved Hilti battery chargers for Li‑ion batteries. 8 Troubleshooting Fault Possible cause Remedy The power tool doesn’t run.
Batteries that have reached the end of their life must be disposed of in accordance with national regulations or returned to Hilti. Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling.
11 EC declaration of conformity (original) Hilti Corporation, Feldkircherstrasse 100, Designation: Cordless drill / driver FL‑9494 Schaan Type: SFC 22-A/SFC 14‑A Generation: Year of design: 2010 We declare, on our sole responsibility, that this product Paolo Luccini Tassilo Deinzer complies with the following directives and standards:...