Table of Contents
Advertisement
1.888.610.7664
Repair service
•
•
•
•
20.3 Storage
Units which are not to be reused must be stored in a dry, place,
protected from dust and frost, after cleaning. The system components
must be fully emptied and carefully dried, for example using compressed
air. Seal the connectors.
21 Repair service
Before asking for a service technician or returning a JULABO unit for
repair, please contact our Technical Service Department.
JULABO Technical Service
If you return a unit to JULABO:
•
Clean the unit to avoid any harm to the service personnel.
•
It is essential that you enclose a short fault description.
•
Before returning the device, please complete an online return form.
•
Ensure careful and adequate packing.
•
JULABO cannot accept any liability for damage caused by incorrect
packaging.
•
In the interest of product improvement, JULABO reserves the right to
make any necessary technical modifications during the repair to
ensure the proper functioning of the unit.
Pos: 5 6 /Technis che D okumentation/Flash CORI O/ CORIO_ CD_GESAMT /Gewährleist ung EU @ 0\mod_ 1409 21845 0062_ 18.docx @ 6 741 @ 1 @ 1
www.calcert.com
15
10
20
5
25
0
30
cloudy and will dissolve the adhesive. Plastic baths will therefore
start to leak.
Clean bath tanks with wet products - never rub them dry. The
cloths or sponges you use should not be contaminated (with
scouring particles or dust).
A good, essentially smear-free cleaning effect can be achieved
using a microfiber cloth moistened with water.
Use warm water with a few drops of washing-up liquid and a soft
cloth to clean the bath.
If it has heavier soiling, particularly if it is greasy, benzol-free
pure benzene (washing benzene, light benzene) can be used for
cleaning.
83
sales@calcert.com
Advertisement
Table of Contents
