1.888.610.7664
5
Safety instructions
It is important to follow these safety instructions to prevent personal
injury and property damage. These instructions apply in addition to
standard safety practices for working places.
•
It is essential that you read the user information before starting the
unit.
•
Use PPE (safety gloves, safety shoes, safety goggles).
•
Transport the unit carefully. The interior of the unit can also be
damaged by impacts or if it is dropped.
•
Do not loiter under the unit during transportation and operation.
•
The unit is not intended for use in potentially explosive areas.
•
Please observe the specifications for the minimum space
requirement when setting up the unit.
•
Only operate the unit in rooms that are well-ventilated, dry and free
of frost.
•
Switch the unit off immediately if there is refrigerant leakage.
•
Place the unit on a flat surface of non-flammable material.
•
Operate the unit under an exhaust hood as much as possible.
•
Do not start the unit if it is damaged or leaking.
•
Compare the mains voltage and frequency with the specifications on
the type plate.
•
Only connect the unit to a fused mains connection via a FI circuit
breaker (Ia=30 mA).
•
Only connect the unit to a power socket with ground contact (PE –
protective earth)!
•
The power supply plug serves as safe disconnecting device from the
power supply network and must be freely accessible at all times.
•
Check the mains cable regularly for signs of damage.
•
Do not start the unit if it has a damaged power cable.
•
Keep the mains cable away from hot pump connections.
•
Refer to the safety sticker. Parts of the unit can be hot or cold.
•
Never use the unit without bath fluid.
•
Do not reach into the thermal bath fluid.
•
Check the filling level of the bath fluid at regular intervals. The pump
and heater must always be completely covered with bath fluid.
•
Adjust over-temperature safety device below the flash point of the
bath fluid.
8
www.calcert.com
15
10
20
5
25
0
30
sales@calcert.com