Table of Contents
Advertisement
1.888.610.7664
8.5
Temperature control for external connected systems
Danger from the incorrect use of external connected
systems.
Unsuitable materials may cause the failure of the system.
Check the externally connected systems for the
following:
•
•
•
The circulator is designed for the temperature control of external
connected systems (temperature control system).
Connect an external system
Remove the union nuts and sealing plates from the pump connectors.
The tube connectors can be used for tubing with M16x1 (internal)
connections in this state.
Tighten the connections with a maximum torque of 3 Nm, holding the
nuts (a.f. 17 mm) as you do so.
Second method
Secure barbed fittings to the union nuts. Tighten the connections with
a maximum torque of 3 Nm, holding the nuts (a.f. 17 mm) as you do
so.
Connect tubing and secure them with tube clamps to prevent them
sliding off.
Connect the tubing for the supply and return to the pump connectors
and the external consumer and secure them with tube clamps.
Switch the pump function to external circulation.
Pos: 2 7 /Technis che D okumentation/Flash CORI O/Dyneo/Te mperierschläuche, Auswa hl, U mgang @ 1\ mod_15 1264 2409 261_1 8.docx @ 125 40 @ 2 @ 1
26
www.calcert.com
15
10
20
5
25
0
30
Compression strength.
Corrosion resistance.
Check the materials used for parts in contact with the medium.
sales@calcert.com
Advertisement
Table of Contents
