Step 5: Connect The Power Cable To Power The Nvr; Step 6: Upgrade Firmware To Latest Version (If Available); Step 7: Verify Camera Image; Step 8: Set The Time - FLIR DN4083E64 Instruction Manual

6
Basic Setup (DNR400 Series)
• Connect a VGA cable (not included) from the VGA port to the monitor.
1. VGA port.
2. HDMI port.

6.5 Step 5: Connect the Power Cable to Power the NVR

• Connect the included AC power cable to the NVR and connect the other end to a
power outlet or surge protector. Then turn the power switch to l to power on the NVR.
At startup, the system performs a basic system check and runs an initial loading se-
quence. After a few moments, the system loads a live display view.

6.6 Step 6: Upgrade Firmware to Latest Version (if Available)

If a firmware upgrade is available, you will be asked to install it once the system starts up.
It is required to upgrade your system firmware and client software or mobile apps to the
latest version to enable remote connection to the system.
If a firmware upgrade is available:
1. After startup, a notification will appear asking you to upgrade the firmware. Click OK
to upgrade.
2. Enter the system user name (default: admin) and password (default: 000000) and
click OK. Wait for the firmware update to complete. The system will restart once the
firmware has been upgraded.
WARNING
DO NOT POWER OFF THE SYSTEM OR DISCONNECT THE POWER CABLE DURING FIRM-
WARE INSTALLATION

6.7 Step 7: Verify Camera Image

• Power on the cameras, and then verify the camera video quality before mounting the
cameras to a permanent location.
• Mount the cameras under a sheltered location. Always verify the outdoor rating of your
camera before installing it in a permanent location.

6.8 Step 8: Set the Time

• Set the system time and date for accurate video time stamps. Videos with inaccurate
times may not be valid as surveillance evidence.
• For details on setting the system time, see 10 Setting The Time, page 23.
#LX400022; r.16694/30364; en-US
9