Table of Contents
Advertisement
PNA Series Microwave Network Analyzer System
System Installation
N5250A
Configuring the PNA Software for the N5250C
Configuring the PNA Software for the N5250C
1. On the PNA, select: Utility > System > Configure > Millimeter Module Configuration. The
dialog box shown in the following figure will be displayed.
Figure 3-8
Millimeter Module Configuration Dialog Box
2. On the dialog box, under Available Configuration(s), select Broadband 10MHz - 110GHz, then click
OK. This activates the N5250C mode for the PNA.
Installation and Service Guide N5250-90001
3-17
Advertisement
Table of Contents
