Specifications; Warranty - Keysight Technologies N5250C PNA Series Manual

System Description
Millimeter-Wave Test Head Modules

Specifications

Specifications described here are the typical performance for the 67 –110 GHz millimeter-wave
test head modules. For the electrical specifications of the modules when used in the N5250C
system, refer to "System Specifications (typical)" on page 4-
The N5260-60004 test head module does not have a built-in attenuator while the N5260-60003
adds a 25-dB variable attenuator inserted between the source multiplier and the source isolator.
See the block diagram,
Table 2-1 Specifications (Typical Performance)
Specifications
System Operating Freq.
RF Input Freq.
RF Input Power
LO Input Freq.
LO Input Power
Test Port (TP) Output Power
TP Output Power Adjustment
TP Input Power Operating Level
TP Input Power Damage Level
Test Port Interface
Additional Interfaces
Power Requirements
Ambient Operating Temperature 20 to 30
Dimensions (L x W x H)

Warranty

The millimeter-wave test head modules are covered by the N5250C system warranty. See
"Service and Support Options" on page 5-
own separate warranty.
2-10
Figure 2-5 on page 2-9.
N5260-60004
67 to 110 GHz
11.167 to 18.333 GHz (x6)
+5 to +13 dBm
8.375 to 13.75 GHz (x8)
+5 to +13 dBm
0 dBm min. +3 dBm typical
N/A
+4 dBm typical, for 0.1
dB compression
+27 dBm
OML precision WR-10 flange
4 ea. SMA (f) (Source, LO, 2 IF)
+12 VDC @ 1.5 A. typical
o
C
13 x 4.3 x 2.7 inches
4. In addition, the test head modules have their
PNA Series Microwave Network Analyzer System
2.
N5260-60003
67 to 110 GHz
11.167 to 18.333 GHz (x6)
+5 to +13 dBm
8.375 to 13.75 GHz (x8)
+5 to +13 dBm
-2 dBm min. +1 dBm typical
25 dB min.
+4 dBm typical, for 0.1
dB compression
+27 dBm
OML precision WR-10 flange
4 ea. SMA (f) (Source, LO, 2 IF)
+12 VDC @ 1.5 A. typical
o
20 to 30 C
13 x 4.3 x 2.7 inches, not including
the attenuator micrometer
Installation and Service Guide N5250-90001
N5250A