Advertisement
Quick Links
Advertisement
Related Manuals for aivituvin AIR 600
Summary of Contents for aivituvin AIR 600
- Page 1 INSTRUCTION MANUAL AIR 600 www.aivituvin.com...
- Page 3 NOTICE Please retain these instructions for future reference. Firmly secure all bolts,screws and knobs before use. Reconfirm that all bolts,screws,and knobs are secure every 90 days. Fasten screws loosely during initial assembly. Do not fully tighten screws until the item is completely assembled. Do not use or store this item in the proximity of open flame or flammable/combustible chemicals.
-
Page 4: Tools Required
TOOLS REQUIRED PHILLIPS DRILL 2PERSON APPROXIMATELY SCREWDRIVER (RECOMMENDED) ASSEMBLY 45MIN. ASSEMBLY HARDWARE M3.5x40mm SCREW M3.5x50mm SCREW 18PCS+1spare 4PCS+1spare M3.5x25mm SCREW M3.5x35mm SCREW 16PCS+1spare 4PCS+1spare M3.0x10mm SCREW M3.0x16mm SCREW 2PCS+1spare 4PCS+1spare Chewing toy... - Page 5 PARTS Left panel of hutch Back panel of hutch Front panel of hutch Right panel of hutch Tray Floor panel of side pen Back panel of side pen Right panel of side pen Top cover of side pen...
- Page 6 PARTS Roof Ramp Roof cap 2PCS Wire mesh floor Black plastic layer Folding metal feeder 2PCS 2PCS...
- Page 7 PARTS Hutch...
-
Page 8: Product Assembly
PRODUCT ASSEMBLY Attach Part A, Part B and Part C by 6xP2 screws. Attach Part D by 2xP2 screws each side. - Page 9 PRODUCT ASSEMBLY Screw the ramp Part K to the right panel of hutch Part D by 4xP5 screws. ① Attach the side pen! ② Screw the Part F, Part G and Part H by 4xP2 screws.
- Page 10 PRODUCT ASSEMBLY ① Attach the pen to the hutch from front by 2xP1 screws as show on picture. ② Put the chewing toy P7 inside the cage anywhere you want. ① Attach the pen to the hutch from back by 2xP1 screws as show on picture.
- Page 11 PRODUCT ASSEMBLY ① Attach 2Pcs of roof Part J to the hutch by 8xP3 screws. ② Notice to level up the same line for two roofs. ③ Slide in the tray Part E. Screw the roof cap Part L by 4xP4 screws.
- Page 12 PRODUCT ASSEMBLY Attach the top cover of side pen Part I by 4xP2 screws. Put the whole hutch above the bottom wire netting 2xPart M to be direction to seperate the urine & poop.
- Page 13 PRODUCT ASSEMBLY Screw the bottom wire netting to the front side by 4xP3 screws. Screw the bottom wire netting to the back side bt 4xP3 screws.
- Page 14 PRODUCT ASSEMBLY If you want to put the hutch indoor, just place the black plastic layer Part N on the bottom to make it super easy to clean. LOCKED OPEN Finish...
- Page 16 WARNING Manufacturer and seller expressly disclaim any and all liability for personal injury,property damage or loss,whether direct,indirect,or incidental,resulting from the incorrect attachment,improper use,inadequate miantenance,or neglect of this product.
Need help?
Do you have a question about the AIR 600 and is the answer not in the manual?
Questions and answers