Cerwin-Vega VEGA Series Manual page 8

Three modes of audio input connections to our HUB monitors:
(1) Audio Input Mode Selection Button, each button press will advance to the next connection type (Bluetooth,
Analog input and then SKAA mode).
(2) Bluetooth Receive Mode: when selected, the BT LED will light up and the HUB will then transmit audio
automatically via a SKAA Pro mode to the SAT.
(3) Line In Analog Receive Mode: when selected, the Analog LED will light up and the HUB will then transmit audio
automatically via a SKAA Pro mode to the SAT.
(4) SKAA Receive Mode: when selected, the SKAA Bond LED will illuminate.
I. If you've Bonded to this audio source before, click the Bond button once (1-click). Repeat again this
procedure if the speaker Bonds and plays the wrong audio.
II. If you've never Bonded to this audio source before, click the Bond button twice (double-click). Repeat
this procedure again if the speaker Bonds and plays the wrong audio.
III. Normally avoid this method since it clears the favorites list in your speaker. If neither method i) nor ii)
listed above work, provide 6-clicks using the Bond Button to factory reset your speaker. The speaker
will then Bond and play audio. If it plays the wrong audio, go to ii).
Note: With one exception, HUB monitor always communicates wirelessly to the SAT using SKAA Pro Audio transmission.
The sole exception to this rule is when the SAT is directly receiving SKAA signals from a source other than the HUB.
Figure 1: HUB Input Audio Connection Controls
8
please see figure 1 Below: