Cerwin-Vega VEGA Series Manual page 19

Question
(Continued)
How do I select Say you want to put your receiver on a high shelf where you can't reach the Bond Button easily. First, set
transmitters if I can't up your Green List: add all of the transmitters you'll want to use. Then 4click the
reach my Bond enter Red Mode. Now put the receiver up on the high shelf. Power on just one of your transmitters and
Button? power off all others. The receiver automatically bonds to the transmitter that's on.
How do I delete a Factory Reset (6 Clicks of the Bond Button) clears the Green List and lets you start over from scratch.
transmitter from my
Green List? If, however, you'd like to delete just one transmitter from your Green List, first bond your receiver to the
transmitter you wish to delete. See the section above: How do I bond with a specific Green transmitter?
Once you are bonded to it, hold down the
flash Red —this Red flash means the transmitter has been deleted.
What is a Cluster? Clusters are an optional convenience for "power users". A Cluster is several SKAA receivers behaving as
one product. A left & right speaker pair, for example, or a sound bar and subwoofer.
What is the Master In any Cluster, there is a single Master receiver, and all of the other receivers in the Cluster follow its
receiver? behavior. You can control the entire Cluster by operating the
must have a physical Bond Button in order to become the Master.
How do I Do the Make a Cluster of Receivers procedure once for each receiver, but omit Step 3. Do them one at a
"Un-cluster" several time. This gives each of the receivers a functioning
receivers? operate independently.
What are some tips Each step in the Make a Cluster of Receivers procedure has a 10second time limit. When you see the
for making Clusters? Master's Indicator start to flash Red, you have 10 seconds to power on the next receiver. When that
receiver's Indicator starts to flash Red, you have 10 more seconds to power on the next one, and so on.
Why does only When you make a Cluster from several receivers, the first one powered on in the Make a Cluster of
one of my Bond Receivers procedure becomes the Master of the Cluster. Only the Master's
Buttons works? because a Cluster uses just one Green List —the Master's Green List. The Bond Button of each of the other
receivers will work only for the Mute / Unmute function (3Click of the Bond Button).
Can any group of No. The receivers must be members of the same product family. If they are not, the Make a Cluster of
receivers be made Receivers procedure won't work. This is because only receivers which were designed to work together (as
into a Cluster? a single product) can be made into a Cluster.
Answer
(Continued)
Bond Button for a few seconds until you see the Indicator
Bond Button, and each of them will thereafter
19
Bond Button to
Bond Button of the Master. A receiver
Bond Button works