Cerwin-Vega VEGA Series Manual page 12

Computer Wireless Connections using SKAA Mode:
Desktop or Laptop (Windows / MacOS / Linux, assuming USB "A" ports, see figure 3 below, bottom right side.
To connect to the HUB using SKAA.
a. Obtain or buy an Ursula SKAA Transmitter (not included) and connect to your computers standard USB "A"
port.
b. No drivers are necessary to be installed into any operating system being used as the SKAA transmitter will
work automatically.
c. Be sure when the SKAA transmitter is attached to your computers USB "A" port that the computer sound
output is set to the SKAA audio mode.
d. Depress the SKAA Bond Button on the HUB monitor following the correct number of bond button presses
using the SKAA
e. Depress the SKAA Bond Button on the SAT monitor using the SKAA
15 and 16 and sound should be heard at that point.
RECEIVER USER'S GUIDE located on pages 15 and 16.
®
Figure 3: Computer or BT source or SKAA Connections to Monitor
assuming your computer has a SKAA transmitter!
RECEIVER USER'S GUIDE located on pages
®
12