Cerwin-Vega VEGA Series Manual page 15

Direct Wired connection:
XLR or TRS Connection:
Connect your wired connections to your HUB using either the XLR Inputs for left and right or the built in TRS connectors
for left and right connection.
Select the Analog mode via the input connection button and cycle button presses until the Analog mode LED is
illuminated.
Following the silk screen line from the XLR/TRS jacks over to the RCA/XLR/TRS slide switch and be sure the slide switch is
set to the XLR/TRS mode.
Begin to play music on your HUB and then move over to your SAT Monitor and if no audio is present then follow the
SKAA® RECEIVER USER'S GUIDE shown on pages 15 and 16 for the amount of SKAA Bond Button presses.
The monitors will continue to remember this connection even after being turned off.
Note: each SKAA transmitter can talk to a total of four speakers in one transmitter connection.
see figure 6 below.
Figure 6: Direct Wired Input Connections
15