Cerwin-Vega VEGA Series Manual page 16

RCA Line in Connection:
see figure 7 below.
Connect your wired connection to your Monitor HUB using the low-level line RCA inputs.
Select the Analog mode via the input mode connection button and cycle the button presses until the Analog mode LED is
illuminated.
Following the silk screen line from the RCA jacks input connection down to the slide switch and set the switch to the RCA
Input position.
Begin to play music on your HUB and then move over to your SAT Monitor and if no audio is present then follow the
SKAA® RECEIVER USER'S GUIDE shown on pages 15 and 16 for the amount of SKAA Bond Button presses.
The monitors will continue to remember this connection even after being turned off.
Note: please see the SKAA® RECEIVER USER'S GUIDE on pages 15 and 16.
Figure 7: HUB Back Panel Direct Line-In Connections
16