Brickcom OSD-040 36x Series Installation Manual page 6

2.2 Wall Box Mounting
Follow the steps to mount the Dome Camera with the Standard/Mini Pendent
Mount and Wall Box Mount.
1. Make a cable entry hole on the wall to insert the cable(s).
2. Attach the Wall Box Mounting to the wall with proper screws and screw
anchors. Then run the cable(s) through the hole on the Wall Box Mounting
with the I/O Cable's connector coming out.
3. Fasten the Standard/Mini Pendent Mount onto the Wall Box Mounting with
the supplied screws and washers. Then thread the cable(s) through the
Standard/Mini Pendent Mount with the cable(s) coming out of the Pendent
Mount's outlet.
NOTE: Please block the cable entry hole with the supplied
sponge to avoid insects entering the Pendent Mount. See the
illustrations in section2.1 Mini Pendent Mount > Step 4.
4. Attach the supplied Waterproof Rubber to the Standard/Mini Pendent
Mount.
5. Thread the cable(s) through the top holder and join the top holder to the
Standard/Mini Pendent Mount with the supplied screws and washers.
Then adjust the Waterproof Rubber over the joint.
6. Connect the Ethernet and I/O cables and hook the safety wired to the
camera.
7. Join the Speed Dome Camera to the top holder with the supplied screw
and washers.
Wall Box Mounting: Wall Box Mounting + Standard/Mini Pendent Mount