Replacing A Hard Drive - Infortrend EonStor DS 1000 Gen2 Series Hardware Manual

Replacing a Hard Drive

WARNING
Keep a replacement on hand before replacing the hard drive. Do not leave the drive
tray open for an extended period of time or the internal airflow will be disrupted.
Handle the hard drives with extreme care. Carry them only by the edges and avoid
touching their circuits part and interface connectors.
To replace a hard drive, follow these steps.
1. Identify the drive tray. Use the firmware utility, SANWatch, or the LED on the
drive tray to identify faulty hard drive(s). The drive bays are numbered from left to
right and from top to bottom.
2. Unlock the drive tray bezel (indicated by the
flat-blade screwdriver to set the bezel lock from lock to the un-lock position.
3. Open the drive tray. Press the button. The spring handle will pop out.
4. Remove the drive tray. Pull the tray one inch away from the enclosure. Wait for
at least 30 seconds for the disk drive to spin down, and then gently withdraw the
drive tray from the chassis.
blue arrow) by using a small
129