5�27�- Leakage Current Alarm - Circutor Computer SMART III FAST 12Vdc Instruction Manual

Computer SMART III FAST 12Vdc
If the value entered is lower than the minimum value or higher than the maximum value, the backlight
of the display flashes and the value entered is replaced with the minimum or maximum value, or with
the last value validated.
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the unit switches to the simulation screen,
SCREEN" .
5�27�- LEAKAGE CURRENT ALARM
In this point the parameters of the leakage current alarm can be configured. Four alarms are linked to
E13
the leakage current: (
Note: The alarm must be enabled (
Press the key to enter editing mode. It is identified by the
digits to be modified.
The parameters to be configured are:
 The alarm value: when the unit exceeds this value, alarm
 Search for the responsible stage: if this parameter is programmed as
a process of connecting and disconnecting all the stages in order to find which ones are
responsible for the leakage and, once they have been detected, cancels them so that they
cannot connect again. The unit triggers alarms
intermittently displayed on the screen.
If the unit has a
stage's search process will not be done even if it is enabled to do so.
 Enable stages: in this parameter, the stages that were disabled by this alarm are enabled
YES
again ( option).
The key increases the digit value and the next option.
The key decreases the digit value and the previous option.
The key skips to the previous digit and the
Instruction Manual
E14 E15
, , and
"5.20.- ENABLING ALARMS"
-type operation configured (see section "5.8.- PROGRAM"), the responsible
Sim
E16
).
).
E13
E13 E15
and
key skips to the next digit.
"5�29�- SIMULATION
symbol and the blinking of the
is triggered.
ON
, the unit performs
and the disabled stages are
99