Rear Vent Configuration With Vertical Termination - Lopi Greenfield GSR2 Manual

18

Rear Vent Configuration with Vertical Termination

• Use the rear vent conversion from
Travis Industries (SKU 94400998).
• Use 8" Diameter Vent
• Horizontal sections require a ¼"
(6mm) rise every 12" (305mm) of
travel.
• A maximum of three (3) 45° or 90°
elbows may be used. Of these
elbows, only one (1) may be a
horizontal elbow (see illustration).
• The termination must fall within the
shaded area shown in the chart.
Use the indicated restrictor position.
NOTE: Restrictor positions are
based upon lab tests. The ideal
restrictor position may vary slightly,
especially when the termination is
near a demarcation line.
• Diffuser must be closed (see page
14).
© Travis Industries
Installation
(for qualified installers only)
2/23/18 - 1479 Greenfield GSR2-Aust